The stickiness setting for the emitter node does not seem to be working as intended. It seems to be an all-or-nothing scenario: when set under 3.3333% it has no visible effect but when put at 3.3334% the fluid grinds to a halt (i assume what should be 100% stickiness)
Hey can you show me the preset where this is the case for you? I’m looking at the iridescent freeze preset and the stickiness seems to adjust properly
Yes of course, below you can see the difference between 3.3333% stickiness and 3.3334% stickiness. Maybe i’m misunderstanding how this setting is supposed to affect the flow but the change seems incredibly drastic.
can you provide this files to me? I can check them out and see if there’s anything i can find
you can find the files here